Honeywell 8,000 BTU Smart Wi-Fi Portable Air Conditioner User Manual - Manuel (Page 14)

10 EN
USE AND OPERATION (CONTINUED)
REMOTE CONTROL
All key functions can be accessed from the remote control.
Use only two AAA or IEC R03 1.5V batteries.
Remove the batteries if the remote control is not in use for a month or longer.
All batteries should be replaced at the same time, do not mix with old batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Properly dispose of used batteries. •
•
•
•
•
Caution:
°F
°C
Power Control
ON / OFF
Temperature Control
When the or key is pressed,
the set temperature is displayed
and may be adjusted
•
•
•
Sleep Control
Swing Control
In running mode: Auto switch off
In stand-by mode: Auto switch on
Press or
button to adjust the time
setting for 1 hour intervals.
Timer setting is available from 1 - 24
hours by pressing the key or
.
When timer is set, press the or key
to set will cancel the timer setting.
Mode Control
• HIGH • MID • LOW • AUTO
ON / OFF
Press button to enable air outlet
louver swinging up and down. Press
button again to disable the swing
function. Swing can only be set from
the remote control.
Press button to change the
operation mode in the order of:
Fan Speed Control
Timer Control
Note:
Battery Installation: Remove the cover on the back of the remote control and insert two AAA
batteries with + and - pointing in the proper direction according to the polarity markings. •
Air Conditioning Dehumidifying
Auto Fan
This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment dose cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment info an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.