Curtis RLED2969A - Manuel (Page 13)

Basic Operation
Turning on and off the TV
■ Turn on the TV
Connect the AC input cable. At this time the TV will enter standby mode. Press the
button on remote control can turn on TV from standby mode.
■ Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your set in standby mode for long periods of time. It is best to unplug the
set from the mains and aerial.
When there is an accident power off, it is recommended to unplug the power cable
from the power socket.
■ No signal
There is No Signal menu on screen when there is no input signal. In ATV/DTV mode, if
there is no signal in
5 minutes, the TV will turn off automatically. In PC mode, the TV
set will automatically turn off in
1 minutes if no input signal. When VGA cable is
connected, the TV turns on automatically.
Programme Selection
■
Using the CH+/CH- on the panel of TV or on the remote control.
Press CH+ to increase channel number.
Press CH - to decrease channel number.
You can select the channel number by pressing 0 to 9. (In ATV mode)
In DTV mode, press number buttons and – button to select channel.
■ Example
To select - channel (e.g. Channel 1): Press 1.
To select -- channel (e.g. Channel 20): Press 2 and 0 in a short time.
To select --.- channel (e.g. Channel 20.1): Press 2, 0, – and 1 in a short time.
Volume Adjustment
■ Press the VOL+/- button to adjust the volume.
■ If you want to switch the sound OFF, press the .
■ You can release mute by pressing the
or increase the volume.
Changing the Input Source
1. You can select the input source by pressing the SOURCE button on the remote
control.
2. Press the
▲/▼button to cycle through the input source, and press the ENTER button
to confirm your choice.
11
■ Using 0- 9 digital buttons and button.
–