Maytag MVWB980BG - Manuel (Page 19)

19
ACCESSORIES
See Installation Instructions for installation accessories
If you experience Possible Causes Solution
Error Code Appears in Display
oL (overloaded)
appears in display
Load too large. If an overload is detected, the washer will drain any water and
detergent in the washer. Remove several items and add HE
detergent. Close lid and press START/PAUSE.
uL (unbalanced load)
appears in display
Load not balanced. The washer is
running a load-balance correction
routine.
Allow the washer to continue. If the dial is flashing and the washer
has stopped, redistribute the load, close the lid, and press START/
PAUSE.
LF (too long to fill)
appears in display
Washer taking too long to fill.
Drain extends more than 4.5" (114 mm)
into standpipe.
Check plumbing for correct drain hose installation. Use drain hose
form and attach securely to drainpipe or tub. Do not tape over drain
opening. See Installation Instructions.
Ld (too long to drain
water) appears in display
Washer taking too long to drain
water. Drain extends more than
4.5" (114 mm) into standpipe.
Check plumbing for correct drain hose installation. Use drain hose
form and attach securely to drainpipe or tub. Do not tape over drain
opening. See Installation Instructions.
Lower drain hose if the end is higher than 96" (2.4 m) above
the floor. Remove any clogs from drain hose. See Installation
Instructions.
HC (Hot and Cold
hoses reversed)
appears in display
Hot and cold inlet hoses have been
installed incorrectly.
This code will appear at the end of the wash cycle to indicate that
cold water hose is connected to the hot water inlet and hot water
hose is connected to the cold water inlet.
Sd (Excess suds)
appears in display
Excessive suds in washer. Washer is
running a suds reduction routine.
Allow the washer to continue. Use only HE detergent.
Always measure detergent, and base detergent quantity on
load size. Follow detergent manufacturer’s instructions. If the dial is
flashing, reselect your desired cycle using a cold wash temperature,
and press START/PAUSE. Do not add detergent.
dL (Lid cannot lock)
appears in display
An item in the load may be keeping
the lid from locking.
Check for items directly under the lid.
lid (Lid opened)
appears in display
Washer lid left open. Close the lid to clear the display. If the lid is left open for more than
10 minutes, the cycle will reset and water in the washer will drain.
dU (Lid cannot unlock)
appears in display
Objects on washer lid prevent it from
unlocking.
Remove objects, such as a basket of laundry, from the top
of the washer.
F## code (F-type
error code) appears
in display
System error code. Press START/PAUSE once to clear the code. Then press
START/PAUSE again to restart washer. If code appears again,
call for service.
Fd (Factory Default) Washer sets back to factory default. To return all options and modifiers to Factory Default, press
POWER/CANCEL, select RINSE/DRAIN & SPIN cycle, and then
press EXTRA RINSE, FABRIC SOFTENER, EXTRA RINSE,
FABRIC SOFTENER within 5 seconds. When done correctly, the
display shows “Fd” for 3 seconds and then unit returns to Standby
Mode.
TROUBLESHOOTING
First try the solutions suggested here or visit our website to possibly avoid the cost of a service call.
In U.S.A. www.maytag.com/product_help – In Canada www.maytag.ca.
Part Number: Accessory
8212526 Washer drip tray, fits under all
31682 All-purpose appliance cleaner
1903WH Laundry supply storage cart