Dacor IF36RNBOL - Manuel (Page 5)

3
Location Requirements
Your Dacor refrigerator can be recessed in an opening between
cabinets or installed at the end of a cabinet run using a side panel
to enclose the refrigerator.
IMPORTANT:
Observe all governing codes and ordinances. ƒ
It is recommended that you do not install the refrigerator near ƒ
an oven, radiator, or other heat source.
Do not install in a location where the temperature will fall
ƒ
below 55°F (13°C).
Floor must support the refrigerator weight, more than 600 lbs
ƒ
(272 kg), door panels and contents of the refrigerator.
Ceiling height must allow for side tipping radius. See
ƒ Tipping
Radius.
Location should permit doors to open fully. See
ƒ Door Swing
Dimensions.
Location must permit top grille removal. See
ƒ Opening
Dimensions.
Opening Dimensions
To avoid tipping during use, the solid soffit must be within 1” ƒ
(2.5 cm) maximum above the refrigerator. If the solid soffit
is higher than 1” (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the
rear wall studs 80” to 90” (203 cm to 229 cm) above the floor.
See Install Anti-Tip Boards for more information.
NOTE: A clearance of ¹⁄
2
” (1.3 cm) must be maintained above
the top grille in order for the top grille to be removed.
Tools and Parts
Tools needed:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Cordless drill ƒ
Drill bits ƒ
Two adjustable wrenches ƒ
Phillips screwdriver ƒ
Small level ƒ
Appliance dolly ƒ
Torx ƒ
®† T15 and T27 screwdrivers
¹¹⁄ ƒ
32
” nut driver
³⁄ ƒ
8
” and ¹⁄
2
” open end wrenches
Allen wrench ( ƒ 5 ⁄
32
”)
¹⁄ ƒ
4
” and 5 /
16
” socket drivers
Tape measure ƒ
Utility knife ƒ
PARTS NEEDED:
Six #8 x 3” (7.6 cm) wood screws (longer screws may be ƒ
needed)
One or two 2” x 4” x 32” (5 cm x 10 cm x 81 cm) wood
ƒ
board(s)
For IF36 models, consult a qualified cabinetmaker or carpenter
ƒ
to make the panels. See the Installation Requirements section
for more information. EF36 models are equipped with stainless
steel finished doors and are shipped complete.
If you are connecting the water line directly to copper tubing
ƒ
and not to a shutoff valve, you need a ferrule, a union, and a
¹⁄
4
” (6.35 mm) compression fitting.
Installation Requirements
† TORX is a registered trademark of Textron Innovations Inc.
"
(1.3 cm)
1 /
2
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.