Dacor IF36RNBOL - Manuel (Page 19)

17
IMPORTANT:
Install the custom handles prior to installing the panels on the ƒ
refrigerator.
Create custom door overlay panels according to the
ƒ
specifications in the Custom Panels and Handles section.
Dacor is not responsible for customer installed molding or
ƒ
decorative panels that need to be removed or replaced to
service the refrigerator.
Handle Installation
Before installing a custom panel assembly, install the custom
handle hardware.
Counter-sink the screw head into the back of the panel to allow
the panel to slide into place smoothly and for proper fit.
Door Panel Installation
Remove all tape and door bracing from the refrigerator and 1.
freezer doors.
Open the refrigerator and freezer compartment doors.
2.
Installation Instructions
Custom Panel and Handle Installation - IF36 Series Models
A. Countersunk screw
Side View
B. Handle
C. Door panel assembly
B
A
C
Front View
Remove the 3.
trims and
corner caps.
Slide the 4.
custom
panels into
the bottom
and hinge
side trims
on the
refrigerator
compartment
and freezer
compartment
doors,
making sure
that the
backer panel
fits into the
hinge side
trims.
Reinstall the
5.
trims and
corner caps.
Remove the protective 6.
skin from the screw
covers. Slide or snap the
screw covers into the
handle trim section.
Check refrigerator level
7.
and alignment. Adjust if
needed.
Continued...
A. Corner caps
B. Refrigerator door trims
C. Freezer drawer trim
B
A
C
A
A
D. Panels
D
D