SMK-Link Electronics Rechargeable Bluetooth Notebook Mouse - Manuel (Page 4)

Charging the Batteries
• It’s recommended that you fully charge the batteries before initial use;
nevertheless it’s ready for set up (see next step) anytime during charging.
• Plug the USB connector of the charge cable (included in the box) into the
computer’s available USB port.
• Connect the mini-USB tip of the cable into the mouse charge port located
at the front end of the mouse.
• The mouse scroll wheel glows indicating the battery power is low and
continues to glow while the batteries are being charged. When fully
charged the scroll wheel will cease to glow.
• The initial charging process may take up to 8 hours. Subsequent recharge
may require less time depending on the level of residual power of the
batteries.
• The mouse is operational during charging; you can continue to use the
mouse while charging it via the USB charge cable.
• You are now ready to set up the mouse to work with your Bluetooth
system. (Note: it’s not necessary to wait for the batteries to be fully
charged before setting up Bluetooth connection to your system.) Turn on
the power by sliding the on/off switch located at the bottom of the mouse
to the “on” position.
Page 5 Page 6
CAUTION
Make sure the computer’s power management is set to disable hibernation
mode while the mouse is being charged. (Go to Control Panel, Power
Options, select “Hibernate” from the tabs and uncheck the box marked
“Enable Hibernation.)