Paradigm Millenia LP XL - Manuel (Page 6)

Pull cables through or along wall and connect following the instructions on the next page.
Align keyhole slots (see inset) on rear of speaker with protruding screw heads on the bracket,
then using an “in and down” motion mount speaker on bracket.
Remove the two flathead screws (not shown). Drill inner pilot holes
then press anchor bolts firmly into drywall and screw in. Now
insert all four flathead screws and tighten.
WARNING! All screws must
be inserted straight and fully
tightened to ensure correct
operation of anchor bolts.
NOTE: When wall-mounting
the Millenia LP 2, attach the
4 self-adhesive bumper pads
to the back of the speaker.
Step 4
Step 3
Step 5
Step 6
The grille logo is magnetic and can be applied in a horizontal or vertical configuration.
WALL-MOUNTING
(continued)
8 9
CONNECTION
Your speakers are equipped with binding posts that can be used with pin
connectors or bare wire. Refer to the diagram at right and using high-quality
speaker cable (see your dealer), connect one speaker at a time to your
receiver/amplifier. Connect the red (+) amplifier terminal to the red (+)
speaker terminal and the black (–) to the black (–) (see below). Push
binding posts to secure.
Turn your amplifier on and listen to your speakers. If you notice a complete
lack of mid-bass and a dislocated image, one or more of your speakers
may be connected out-of-phase (their polarity is reversed). Re-check to
ensure that each speaker’s cable is connected with correct polarity: red (+)
to red (+) and black (–) to black (–). Make sure wires are firmly fastened.
Push binding posts to secure.
TROUBLESHOOTING
SOLUTION
MINIMUM GAUGE REQUIREMENTS
LENGTH DIAMETER GAUGE
Under 4.5 m (15 ft) 1.3 mm (0.05 in) 16 awg
Under 9 m (30 ft) 1.6 mm (0.06 in) 14 awg
Over 9 m (30 ft) 2.0 mm (0.08 in) 12 awg
PROBLEM
No Sound from One
or More Speakers
No Sound
Lack of Bass or
Dislocated Image
• Make sure receiver, preamp or amplifier is plugged in and turned on.
• Check power outlet at the wall is working.
• Are headphones plugged in, or is the system on Mute?
• Re-check all connections.
• Check your balance control.
• Check that all power cords are properly plugged in and functioning.
• One or more speakers may be connected out of phase
(their polarity is reversed).
• Re-check to ensure that each speaker’s cable is connected with
correct polarity: red (+) to red (+) and black (-) to black (-).
3.258”
Turn your amplifier OFF before connecting speakers. This will avoid damage
which could result from accidental shorting of speaker cables.
SPEAKER
RECEIVER/AMPLIFIER
The following chart identifies the minimum gauge requirements for various cable lengths: