Making the lp conversion (cont.), H change cooktop burner orifices, El change cooktop burner orifices (cont.) – GE JGP329DETBB Manuel d'utilisation
Page 14: Making the lp conversion, Installation instructions, Cont.)
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Installation Instructions
MAKING THE LP CONVERSION
(CONT.)
H CHANGE COOKTOP BURNER
ORIFICES
H Remove the top grates,
burner caps, and burner
heads.
E Remove the spark
igniters from the burner
base (if required to
access the orifices).
Using a No. 15 "Torx"
head driver bit, remove
the screws holding the
burner base in position.
E Using a 7mm nut driver,
remove the top burner
orifices. These may be
accessed through the
hole in the cooktop.
Remove This
Assembly
Orifice
Spud
Located
Through This Opening
Burner cap
Burner
head i
Spark igniter
18,000 BTU Burner
(on some models)
Spark igniter
3
Retainer
Ring
[El CHANGE COOKTOP BURNER
ORIFICES (CONT.)
On most burners, the orifices
have a spring-loaded retaining
ring around the hex head
to hold the orifice in the nut
driver during installation and
removal. A slight amount of
force is required to push the nut driver down over
the ring.
NOTE:
For orifices that do not have a spring-
loaded retaining ring, use pliers to hold the orifice
in position during initial thread
engagement or final removal to
avoid dropping the orifice in the
cooktop. Then use the nut driver
to tighten or loosen.
14