GE JGP970BEKBB - Manuel (Page 10)

Cleaning the glass cooktop surface.
(on some models)
Clean your cooktop after
each spill. Use CERAMA
BRYTE^ Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE® Ceramic Cooktop
Cleaner on the glass cooktop. Other creams
may not be as effective.
To maintain and protect the surface of your
glass cooktop, follow these steps:
Before using the cooktop for the first time,
remove the burner grates and clean the
cooktop with CERAMA BRYTE® Ceramic
Cooktop Cleaner. This helps protect the
top and makes cleanup easier.
Daily use of CERAMA BRYTE® Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
~J] Shake the cleaning cream well. Apply a
few drops of CERAMA BRYTE® Ceramic
Cooktop Cleaner directly to the cooktop.
Use a paper towel or CERAMA BRYTE®
Cleaning Pad for Ceramic Cooktops to
clean the entire cooktop surface.
Use a dry cloth or paper towel to
remove all cleaning residue. No need to
rinse.
NOTE: It IS very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Use a CERAMA BRYTE® Cleaning
Pad for Ceramic Cooktops.
Burned-On Residue
A warning :
DAMAGE to your
glass surface may occur if you use scrub
pads other than those recommended.
Allow the cooktop to cool.
Remove the burner grates and spread a
few drops of CERAMA BRYTE® Ceramic
Cooktop Cleaner on the entire burned
residue area.
Using the included CERAMA BRYTE®
Cleaning Pad for Ceramic Cooktops, rub
the residue area, applying pressure as
needed.
lp\ If any residue remains, repeat the steps
listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMA BRYTE®
Ceramic Cooktop Cleaner and a paper
towel.
The CERAMA BRYTE® Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts Center.
See instructions under "To Order
Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
7] Allow the cooktop to cool.
Remove the burner grates. Use a single­
edge razor blade scraper at
approximately a 45° angle against the
glass surface and scrape the soil. It will
be necessary to apply pressure to the
razor scraper in order to remove the
residue.
After scraping with the razor scraper,
spread a few drops of CERAMA BRYTE®
Ceramic Cooktop Cleaner on the entire
burned residue area. Use the CERAMA
BRYTE® Cleaning Pad to remove any
remaining residue.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMA BRYTE®
Ceramic Cooktop Cleaner and a paper
towel.
10