Solving common dishwashing problems, Solution chart – Whirlpool 935 Series Manuel d'utilisation
Page 24
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Solving Common
Dishwashing Problems
A convenient checklist for handling minor performance problems. Go over this list before
calling for service. If you are unable to solve your dishwasher’s problem, turn to the
‘Troubleshooting” section for service information.
Solution chart
PROBLEM
CAUSE
SOLUTION
Food soil left
Improper loading
See the "Loading Your Dishwasher” section.
on dishes
Water temperature
Use the High Temp Wash option. If needed.
too low
turn home water heater up to ensure water
entering dishwasher is 120°F (49'^C) mini
mum. See the “To check water temperature”
section.
NOTE: In some cases, loads may not dry as
well when using the High Temp Wash option.
Use of incorrect, too
Use recommended dishwasher detergents
little, or ineffective
only. See the "Using the Dispensers” section.
detergent
Never use less than one tablespoon per
load. Detergent must be fresh to be effective.
Always store detergent tightly-closed in a
cool, dry place.
Detergent cakes in
Use fresh detergent only. Do not allow
dispenser
detergent to sit for several hours in a wet
dispenser. Check dispenser for caked
detergent. Clean dispenser when caked
detergent is present.
Insufficient fill due to
Home water pressure should be 20 to 120
low water pressure
pounds per square inch (psi) (138 to
828 kPa) for proper dishwasher fill. A booster
pump on the water supply may be necessary
if pressure is too low.
Slowdown of wash
Never use soap or laundry detergents. Use
arm due to high suds
recommended dishwasher detergents only.
Spotting
Hard water or high
Use rinse agent to help prevent spotting and
and filming
mineral content in
filming. See the "Loading Your Dishwasher”
water
section. To remove hard water film, see
“Removing spots and film” at the end of
this section.
Water temperature
Use the High Temp Wash option. If needed.
too low
turn home water heater up to ensure water
entering dishwasher is 120°F (49°C) mini
mum. See the “To check water temperature”
section.
NOTE: In some cases, loads may not dry as
well when using the High Temp Wash option.
24