Craftsman 919.72413 - Manuel (Page 19)

19 - ENG A08394
TROUBLESHOOTING
Performing repairs may expose voltage sources, moving
parts or compressed air sources. Personal injury may
occur. Prior to attempting any repairs, unplug the air compressor and
bleed off all air tank air pressure.
PROBLEM CAUSE CORRECTION
Pressure switch does
not shut off motor when
compressor reaches "cut-
out" pressure.
Pressure switch "cut-out"
too high.
Move On/Auto/Off lever to
the "Off" position, if the
outfit does not shut off
contact a Trained Service
Technician.
Contact a Trained Service
Technician.
Excessive tank
pressure - safety
valve pops off.
Tube fittings are not tight
enough. Tighten fittings where air
can be heard escaping.
Check fittings with soapy
water solution. Do Not
Overtighten. Air leaks at
fittings.
Air leaks in air
tank or at air
tank welds. Defective air tank. Air tank must be replaced.
Do not repair the leak.
Do not
drill into,
weld or otherwise modify
air tank or it will weaken.
The tank can rupture or
explode.
Air leaks
between head
and valve plate. Leaking seal. Contact a Trained Service
Technician.
Possible defect in safety
valve. Operate safety valve
manually by pulling on ring.
If valve still leaks, it should
be replaced. Air leak from
safety valve.
Possible defect in safety
valve. Operate safety valve
manually by pulling on ring.
If valve still leaks, it should
be replaced. Knocking Noise.