Panasonic AG-TL500 - Manuel (Page 11)

0 When the shift ( V ) button is pressed, the hour
digits flash. Press the SET (+, -) buttons to set the
hour to “3".
© When the shift ( 0 ) button is pressed, minute di­
gits flash. Press the SET (+, -) buttons to set the
minutes to “25”.
( T I M E A D J U S T ) P I
3 - 0 3 - 9 8 T U E
3 : 2 5 : 0 0
^ i JIME
O When the MENU/REC LOCK switch is set to OFF,
the clock automatically starts running from time
and date set.
( T I M E A D J U S T ) P I
. , . TIME
; *
-1% n n
( T I M E A D J U S T ) P I
3 - 0 3 - 9 8 T U E 3 - 0 3 - 9 8 T U E
3 : 0 0 : 0 0 3 : 2 5 : 0 0
TIME
D DC
D L _i.
For the seconds, “00” is set. Even when the switch
is set to MENU, the time will keep advancing if it
has not been changed.
To clear the date and time display, set POSITION under (DISPLAY) on Menu Screen 2 to OFF.
Even if the power should fail for a period of up to one week, the date, time and time mode display (internal
timer setting alarm recall) data are stored in the memory (but only if power has been supplied continuously to
the unit for 3 or more days). When the unit has just been purchased or when it has not been used for along
time, the data is not stored in the memory and the display shown below appears.
( T I M E A D J U S T )
1 - 0 1 - 9 6 M O N
0 : 0 0 : 0 0
P I
All the internal timer settings are set to OFF,
and the alarm recall display is cleared.
For the date setting, the unit automatically adjusts for leap years.
Due to temperature fluctuations and other factors, the clock time may run fast or slow with a monthly error of
up to ±60 seconds. This is not indicative of malfunctioning. Reset the time at regular intervals.
Summer time setting
When the SUMMER TIME button is pressed with a small screwdriver, the time is automatically advanced by one
hour, and at the same time “SUM" appears on the display. When the button is pressed again, the time returns
to its original setting, and at the same time “SUM” disappears from the display.
• The following phenomenon occurs when the date and time are set with the summer time setting.
<Example> 1 2 - 3 1 - 1998 (THU) 23:22:00
When the "hour" has been changed, be absolutely sure to check that the date is correct.
“Hour” setting Date Example
23-^0 Moved up by 1 day 1 -1 -1999 (FRI) 0:22:00
0-> 1 Moved down by 1 day 1 2 - 3 1 -1998 (THU) 1:22:00
1 ^0 Moved up by 1 day 1 - 1 - 1999 (FRI) 0:22:00
0^23 Moved down by 1 day 1 2 - 3 1 - 1998 (THU) 23:22:00
1 1