Starting up/shutting down, Starting up, 1 open the display – Panasonic CF-37 Series Manuel d'utilisation

Page 15: 2 turn your computer on, Select a device to start up the operating system, Full

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

Starting Up/Shutting Down

Starting Up

1

Open the display

(l) Slide the latch as shown,

d) Lift open the display.

2

Turn your computer on

Slide the power switch as shown and hold it for approximately one second until the
power indicator turns on before releasing it.

r

The computer will not power on when the display is closed (except when
connecting an external display or when ¡Panel Switch] has been set to [LCD

Off] in the Setup Utility C?

"Setup Utility").

After confirming that the power indicator has turned on, avoid the following
until Windows has completed loading,

• Touching the power switch.
• Performing any keyboard, touch pad. touchscreen (or external mouse) op­

erations.

• Closing the display.

If the display is closed while Windows is starting up. it is possible that color,

etc., will not be displayed properly. Run the ¡MS-DOS Prompt] ([Start] -

[Programs] - [MS-DOS Prompt]), and use full screen display mode by press­

ing CSD+CÌtìÌD

____ ___________

After returning from the

full

screen mode

CM)

+

C Enter

)

again, the

display will be shown coirectly.

Once the computer is powered off, you must wait at least ten seconds before

powering it on again.
When the CPU temperatale ri.ses, the computer may not power on to prevent the

CPU from overheating. Should this happen, iillow the computer to cool down then
switch the power on again.

If the computer still does not power on, plea.se contact Panasonic Technical Support.

Select a device to start up the Operating System

You can select the device for starting up the Operating System when starting up the

computer. It is not necessary to change the settings of the [Boot] menu in the Setup

Utility.

1

Turn the computer on and press [

Esc

) when [Press <E.sc> to enter Boot First Menu]

is displayed,

2

Select the device from the menu, press (

Enter).

X

note

>

When the Operating System is unable to start up from the selected device, it
will start up from the device last used for start up.

If no start up device is selected, the Operating System will start up in the

order of the settings of the [Boot] menu in the Setup Utility during subse­
quent start ups.
When you want to change the settings in the Setup Utility, select <Enter
Setup> from the menu.

15

Advertising