Panasonic CF-37 Series - Manuel (Page 10)

First-time Operation
Latches
@ Position the cover so that the edge of the cover is aligned with the lines of the
computer.
Then, while lightly pressing down on the center of the cover (with suppressing the
back of the computer by one hand), gently slide the cover until it snaps into place.
Be careful not to get your fingers caught in the cover.
Lines
4Connect your computer to a power outlet
r
Be sure the AC adapter is connected until completing Step 6on page II.
Handling the AC adapter
• Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
• Use only the specified AC adapter with your computer. Using an AC adapter
other than the one supplied might damage the battery and/or the computer.
• When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
• Problems such as sudden voltage drops may arise during periods of thunder
and lightning. Since this could adversely atfect your computer, an uninten uptible
power source (UPS) is highly recommended unless the biittery pack is installed.
Turn your computer on
Slide the power switch and hold it for approximately one second until the power
indicator (^) turns on before releasing it.
r
• After confirming that the power indicator has turned on, do not touch the
power switch until Windows setup has started.
• Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
^NOTE>
The power saving function is factory set, so if there is no input from a key, the
touch pad, or the external mouse for two minutes, the LCD is powered off (ECO
mode O ’ " C o m p u t i n g on the Road" )*.
In the ECO mode the LCD will resume operation when the touch pad is used, or
when a key or the touchscreen is pressed.
The computer may enter the ECO mode while Windows is setting up or even
when an application software is being installed. In this case, because it is con­
ceivable that a selection dialog box will be shown, for resuming from the ECO
mode, do not press C Enter ] which may trigger a selection, instead, press a key
unrelated to the direct triggering of a selection, like C Ctrl )key.
* This excludes a pointing device connected to the USB port, e.g,, a USB mouse.
10