Panasonic WV-CM1430 - Manuel (Page 6)

INSTALLATION
The Rack Angle Bracket WV-Q104 is provided for
mounting the Color Video Monitor WV-CM1430 on the
standard 19" EIA rack.
(1) Remove four screws on both side of WV-CM1430.
These screws are no use after this.
(2) Fix the Rack Angle Bracket by using the supplied
four screws (M4 x 12).
(3) Mount the WV-CM1430 onto the rack by using the
eight screws (local procurement).
— Cautions
CABLE INFORMATION
Power Cable
1. Keep the Power Switch in the OFF position during
installation.
2. Connect the Power Cord to a grounded electrical
outlet.
Video Cable
1. Use 75-ohm coaxial cable. [RG-59/U (3C-2V), RG-
6/U (5C-2V), RG-11/U (7C-2V), RG-15/U (10C-2V)]
2. Up to 10 monitors can be hooked up in this configu­
ration before signal loss occurs. Total cable length
should not exceed 150 m (500 feet).
Do not block the ventilation opening or slots on
the cover to prevent the monitor from rising tem­
perature. Always keep the temperature in the
rack within 50°C (122°F).
Secure the rear of the monitor to the rack by
using the additional mounting angles (procured
locally) when the vibration is added to the rack.
3. Wiring Precautions:
• Do not bend coaxial cable into a curve whose
radius is smaller than 10 times of its diameter:
• Never crush or pinch the cable.
All these will change the impedance of the cable
and cause poor picture quality.
Type of
coaxial cable RG-59/U
(3C-2V)
RG-6/U
{5C-2V)
RG-11AJ
(7C-2V)
RG-15/U
{10C-2V)
Recommended
maximum
cabfe length
(m) 250 500 600 800
(ft) 825 1 650 1 980 2 640
-
4
-