Maintenance, Care, Cleaning the water inlet filters – LG WT1201CV Manuel d'utilisation

Page 27: O note, Ra warning, Care in cold climates, 7 press(^to rinse + spin, Warning, 3 press('"ug)to spin only

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

MAINTENANCE

27

MAINTENANCE

Care

Cleaning the Water Inlet Filters

If the washer detects that water is not entering the

dispenser, an error message will show on the display. If

you live in an area with hard water, this may be caused by

clogged inlet filters.

O NOTE-----------------------------------------

• Use extreme care when removing and cleaning the

filters. If the filters cannot be cleaned or are damaged,

do NOT operate the washer without the inlet filters.

Contact LG Customer Service or a qualified LG servicer.

r

1 Turn off both water taps completely. Unscrew the hot and

cold water lines from the back of the washer.

2 Carefully remove the filters from the water inlets, and

soak them in white vinegar or a lime scale remover. Rinse

thoroughly before reinstalling. Press the filters back into

place and reattach the water lines. Do NOT operate the

washer without the inlet filters.

rA

WARNING------------------------------------

Unplug the power cord and turn off the faucets before

cleaning.

Failure to do so may cause electric shock.

Do not use the washing machine without the inlet

filters.

If you use the washing machine without

the inlet filters it will cause leaks and malfunction.

If you use the washing machine in an area with hard

water, the inlet filter may be clogged due to lime buildup.

Contact your nearest LG customer service center if the

inlet filter is not clean or is missing.

Q NOTE---------------------------------------

/1

message will blink on the display when the water

pressure is weak or an inlet filter is clogged with dirt.

Clean the inlet filter.

Care in cold climates

When the Water Line is frozen

1

Turn off the faucets connected with the water lines.

2

Pour hot water on the frozen faucets to thaw the water

lines and pull them out.

3

Immerse the water lines in hot water to thaw them.

4

Connect the water lines with the water inlets of the

washing machine and faucets.

- See page 14,

Connecting the water lines

for details.

5

Turn on the faucets.

6

Press

a

S

tow

.

7 Press(^to RINSE + SPIN.

8

Press

- Verify the water fills properly.

When the Drain Line is Frozen

1

Pour hot water in the washer tub and close the lid.

- Leave it for 10 minutes.

2

Press

a

S

tooff

after 10 minutes.

3 Press('"ug)to SPIN ONLY.

4

Press

- Check if the water drains.

Advertising