Adjusting the recording level, Adjusting the digital recording level, To turn on the peak hold function using the remote – Sony MDS-JB920 Manuel d'utilisation
Page 15: Adjusting the analog recording level, Over indication, Recording on mds
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Recording on MDs
Adjusting the Recording Level
You can adjust the recording level before starting
recording.
REC LEVEL
MENU/NO (DIGITAL/ANALOG)
P. HOLD
DIGITAL REC LEVEL
/ANALOG OUT LEVEL +/-
Adjusting the digital recording level
You do not normally need to adjust the digital
recording level. The level is adjusted mainly when the
level of the source is low.
1
Do Steps 1 to 6 in "Recording on an MD" on •
pages 9 and 10.
2
Play the portion of the program source with the
strongest signal level.
3
While monitoring the sound, turn outer REC
LEVEL (DIGITAL) (or press DIGITAL REC
LEVEL/ANALOG OUT LEVEL +/-) to adjust the
recording leve] so that the peak level meters reach
their highest point without turning on the OVER
indication. Occasional lighting of "OVER" is
acceptable.
4
Stop playing the program source.
5
To start recording, do the procedure starting trom
Step 8 in "Recording on an MD" on page 10,
^ The Peak Hold Function freezes the level meter
display at the highest level reached by the input
signal
To turn on the Peak Hold Function by Setup Menu 06
setting
1
While the deck is stopped, press MENU/NO twice to
display "Setup Menu".
2
Turn AMS to select "Setup 06", then press AMS.
3
Turn AMS to select "P.Hold On", then press AMS.
4
Press MENU/NO.
To turn on the Peak Hold Function using the remote
Press P.HOLD to display "P.Hold On."
To turn off the Peak Hold Function, select "P.Hold Oft"
in Step 3 above. (Or press P.HOLD on the remote to
display "P.Hold Off".)
Adjusting the analog recording level
1
Do Steps 1 to 6 in "Recording on an MD" on
pages 9 and 10.
2
Play the portion of the program source with the
strongest signal level.
3
While monitoring the sound, turn inner REC
LEVEL (ANALOG) to adjust the recording level.
If the output level of the connected component is
too low, it may not be possible to set the
recording level to maximum.
4
Stop playing the program source.
5
To start recording, do the procedure starting from
Step 8 in "Recording on an MD" on page 10.
- [•■ ! 01'l T V a c к r
/ / / / / i ! i \ \ \
' ►IIEB
to
4 Tr l_l ri'i IJ l_l S 1
OVER indication
If the digital signal level of the source is too low,
it may not be possible to set the recording level to
maximum.
1 5
^