9 selector, Ha/ delay selector, A/rgb selector – Sony PVM-1351Q Manuel d'utilisation
Page 5: Under scan selector, Bl.ue only selector reset button, Degauss button, Ext sync (external sync) selector, Line/rgb input selector, C/sdi selector, B/component selector
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
16:9 selector
Press (light on) for the signal of 16:9 picture.
HA/ DELAY selector
Press (light on) to observe the horizontal and \'ertical
sync signals at the same time.
The horizontal svnc signal is displayed in the left quarter
o f the screen; the v e r t i c a l sync signal is displa\'ed near
the center of fhe screen.
A/RGB selector
When the LINE/RCB input selector is set to LINE (light
i)ff), press this button (light on) to feed a signal through
the LINE A connectors.
When the UN'E/RGB input selector is set to RGB (light
on), press this button (light on) to feed the RGB signal.
3
(Q
UNDER SCAN selector
Press (light on) for underscanning. The display size is
reduced by approximately 3% so that four corners of the
raster are x'isible.
BL.UE ONLY selector
RESET button
Press (light on) to turn off the red and green signals. A
blue signal is displayed as an apparent monochrome
picture on the screen. This facilitates "chroma" and
"phase*" control adjustments and observation of VCR
noise.
* "Phase" control adjustment is effectix e onlv for the
NTSC signals.
Press to reset the setting in the menu.
DEGAUSS button
Press this button momentarily. The screen will be
demagnetized. Wait for 10 minutes or more bek)re
activating this button again.
EXT SYNC (external sync) selector
Keep this button in the off position (light off) to operate
the monitor on the sync signal from the displayed \ ideo
signal.
Keep this button in the on position (light on) to operate
the monitor on an external svnc signal fed through the
EXT SYNC connector on the rear panel.
LINE/RGB input selector
Select the program to be monitored. Keep this button in
the off position (light off) to feed a signal through the
LINE A, LINE B or LINE C connectors. Keep this button
in the on position (light on) to feed a signal through the
RGB connectors.
C/SDI selector
When the LINE/RGB input selector is set to LINE (light
off), press this button (light on) to feed a signal thix)ugh
the LINE C connectors,
When the LINE/RGB input selector is set to RGB (light
on), press this button (light on) to feed the SDI signal
(optional board is needed).
B/COMPONENT selector
When the LINE/RGB input selector is set ti) LINE (light
off),'press this button (light on) to feed a signal through
the LINE B connectors.
When the LINE/RGB input selector is set to RGB (light
on), press this button (light on) to feed the component
signal.