Sony PVM-1351Q - Manuel (Page 3)

Features
HR (High Resolution) Trinitron picture tube
HR Trinitron tube provides a high resolution picture.
Horizontal resolution is more than 600 (PVM-1354Q/ 1954Q)
or 430 (PVM-1351Q) TV lines at the center of the picture.
Four color systems available
4 he monitor can display PAL, SECAM, NTSCos and
NTSCi r:* signals. The appropriate color system is selected
automatically.
* A signal of NTSCTm is used for playing back NTSC
recorded yideo cassettes with a yideo tape recorder/
player especially designed for use with this system.
Blue only mode
In thejTjue only mode, an apparent monochrome displa\' is
obtained with all three cathodes dri\’en v\’ith a blue signal.
This facilitates color saturation and phase adjustments and
obserx'ation of VCR noise.
Analog RGB/component input connectors
Analog RGB or component (Y, R-Y and B-Y) signals from
\ ideo equipment can be input through these connectors.
Y/C input connectors
The \'ideo signal, split into the chrominance signal (C) and
the luminance signal (Y), can be input through this
connector, eliminatiiig the interference between the tv\'o
signals, which tends to occur in a composite \ ideo signal,
assuring yideo quality.
Beam current feedback circuit
The built-in beam current feedback circuit assures :
white balance. ■table
Horizontal/vertical delay mode
The horizontal and vertical sync signals can be checked
simultaneously in the H/V delay mode.
External sync input
When the EXT SYNC selector is in the on position, the
monitor can be operated on the sync signal supplied from
an external s\’nc generator.
Auto/manual degaussing
Degaussing of the screen can be performed automatically
when the power is turned on, or manually b\' pressing the
DEGAUSS button.
On-screen menus
You can set color temperature, CHROM/X SE 1^ UP, and
other settings by using the on-screen menus.
Five menu languages
You can select the menu language from among the fix'e
languages on the menu.
EIA standard 19-inch rack mounting
By using an MB-502B (for PVN4-1354Q/ 1331Q) or SLR-103
(for PVM-1934Q) mounting bracket (not supplied), the
monitor can be mounted in an EIA standard 19-inch rack.
For details on mounting, see the instruction manual of the
mounting bracket kit.
SDI (Serial Digital Interface) kit
B\' using SDÌ kit, the monitor can dispiax' SMITE 239M 4:2:2
serial ctigital signal from a digital VTR. (e\. Sony 4:2:2 \'TR)
SDI kit: 4:2:2 digital \ ideo board
Digital audio board
3
(Q
Comb filter
When N ESC video signals are recei\ ed, a comb filter
acti\ ates to increase the resolution, resulting in fine picture
detail without color spill or color noise.
Automatic termination
(connector with VV mark only)
The input connector is terminated at 75 ohms inside when
no cable is connected to the loop-through output
connectors. When a cable is connected to an output
connector, the 75-ohms termination is automaticaih released.
Underscan mode
The signal normally scanned outside of the screen can be
monitored in the underscan mode.
When the monitor is in the underscan mode, the dark RGB
scanning lines may appear on the top edge of the screen.
These are caused by an internal test signal, rather than the
input signal.