Chamberlain 1280 - Manuel (Page 4)

Safety Reversing Sensor
Support bracket &
fastening hardware
is required.
See page 13.
—
—
—
—
—
—
—
—
Door
Center
Header Wall
FINISHED CEILING
Torsion
Spring
Extension
Spring
OR
Safety
Reversing
Sensor
Gap between floor
and bottom of door
must not exceed 1/4"
Access
Door
Wall-
mounted
Door
Control
Horizontal and vertical reinforcement
is needed for lightweight garage doors
(fiberglass, steel, aluminum, door with
glass panels, etc.). See page 20 for details.
Motor unit
4
SECTIONAL DOOR INSTALLATION
Planning
Identify the type and height of your garage door. Survey your garage area to see if any of the conditions below
apply to your installation. Additional materials may be required. You may find it helpful to refer back to this page
and the accompanying illustrations as you proceed with the installation of your opener.
Safety Reversing
Sensor
Header
Wall
Safety Reversing
Sensor
Gap between floor
and bottom of door
must not exceed 1/4"
FINISHED CEILING
Support bracket
& fastening hardware
is required. See page 13
Access
Door
Wall-mounted Door Control
Motor Unit
ONE-PIECE DOOR WITHOUT TRACK
Access
Door
Floor must be level
across width of door
Safety
Reversing Sensor
Safety
Reversing Sensor
ONE-PIECE DOOR WITH TRACK