Din rail mounting, Replacing a single module within a system – Rockwell Automation 1769-ARM Compact Address Reserve Module Manuel d'utilisation

Page 9

Advertising
background image

Compact™ Address Reserve Module 9

Publication 1769-IN071A-EN-P - September 2004

DIN Rail Mounting

The module can be mounted using these DIN rails:

• 35 x 7.5 mm (EN 50022 - 35 x 7.5)
• 35 x 15 mm (EN 50022 - 35 x 15)

Before mounting the module on a DIN rail, close the DIN rail latches. Press the DIN rail
mounting area of the module against the DIN rail. The latches will momentarily open and
lock into place.

Replacing a Single Module within a System

The module can be replaced while the system is mounted to a panel (or DIN rail).

1. Remove power.

2. On the module to be removed, remove the upper and lower mounting screws from

the module (or open the DIN latches using a flat-blade or phillips style screw driver).

3. Move the bus lever to the right to disconnect (unlock) the bus.

4. On the right-side adjacent module, move its bus lever to the right (unlock) to

disconnect it from the module to be removed.

5. Gently slide the disconnected module forward. If you feel excessive resistance, check

that the module has been disconnected from the bus, and that both mounting screws
have been removed (or DIN latches opened).

It may be necessary to rock the module slightly from front to back to remove it, or, in
a panel-mounted system, to loosen the screws of adjacent modules.

6. Before installing the replacement module, be sure that the bus lever on the module to

be installed, and on the right-side adjacent module are in the unlocked (fully right)
position.

ATTENTION

Remove power before removing or inserting this module. When you
remove or insert a module with power applied, an electrical arc may occur.
An electrical arc can cause personal injury or property damage by:

• sending an erroneous signal to your system’s field devices, causing

unintended machine motion

• causing an explosion in a hazardous environment

Electrical arcing causes excessive wear to contacts on both the module
and its mating connector. Worn contacts may create electrical resistance.

Advertising