Rockwell Automation 1769-ARM Compact Address Reserve Module - Manuel (Page 7)

Compact™ Address Reserve Module 7
Publication 1769-IN071A-EN-P - September 2004
6. To allow communication between the controller and module, move the bus lever fully
to the left (4) until it clicks. Ensure it is locked firmly in place.
7. Attach an end cap terminator (5) to the last module in the system by using the
tongue-and-groove slots as before.
8. Lock the end cap bus terminator (6).
Mounting Expansion I/O
Minimum Spacing
Maintain spacing from
enclosure walls, wireways,
adjacent equipment, etc.
Allow 50 mm (2 in) of space
on all sides for adequate
ventilation.
ATTENTION
When attaching I/O modules, it is very important that the bus
connectors are securely locked together to ensure proper
electrical connection.
IMPORTANT
A 1769-ECR or 1769-ECL right or left end cap must be used to terminate
the end of the serial communication bus.
ATTENTION
During panel or DIN rail mounting of all devices, be sure that all debris
(metal chips, wire strands, etc.) is kept from falling into the module.
Debris that falls into the module could cause damage on power up.
Controller
Compact I/O Compact I/O Compact I/O Compact I/O Compact I/O
End Cap
Top
Bottom
Side Side