WarmlyYours Metropolitan Towel Warmer - Manuel (Page 4)

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
METROPOLITAN INSTALLATION MANUAL
ITEM# TW-MT-10PS-HW-HD
SAFETY INFORMATION
• Towel warmers are designed to warm towels only and should not be
used for any other purpose.
• Never stand, sit on or hang on the towel warmer.
• Never allow children to play on or with the towel warmer.
• Make sure that the circuit breaker is shut off at the main electrical panel
before wiring or servicing your towel warmer.
• The towel warmer must be properly grounded.
• All wiring must be done in accordance with the National Electrical Code
(NEC) and Canadian Electrical Code (CEC) and should be performed by
a licensed professional who is certified to do electrcal wiring.
• Never place your towel warmer inside a shower, sauna or steam room.
• Never attempt to warm more than two (2) towels on the
towel warmer at a time. Overloading the towel warmer will cause
the unit to become extremely hot and may result in a burn if touched.
• Towel warmers are cULus listed for use in U.S. and Canada.
CLEANING INFORMATION
While the towel warmer is warm, clean with a soft, non-abrasive, damp
cloth. Once the towel warmer has cooled, lightly polish with a soft, dry
cloth. Do not use abrasive cleaning powders, metal polish or chlo-
rine-based cleaners on any part of the towel warmer.
INSTALLATION
This appliance must be installed in accordance with the instructions in the
manual and the NEC and CEC guidelines relating to electrical fixtures in
bathrooms. The towel warmer MUST be on a GFCI protected circuit and
wired by a licensed professional who is certified to do electrical wiring.
OPERATION
After installation is complete, connect the electric power and turn on
the power switch, located on the bottom left of the unit. The unit will
begin to heat. If the unit will not be used for an extended time, simply
turn the unit off using the power switch.
IMPORTANT: READ BEFORE INSTALLING
1. Read installation manual and ALL instructions BEFORE you
begin installation.
2. WarmlyYours recommends mounting the left vertical rail mounts
to a stud.
3. This product is not intended for commercial use. Residential
use only. Do not put the unit into water. This product is for indoor
use only.
4. If the heating wire inside the unit fails or becomes damaged, turn
the unit OFF and contact WarmlyYours. Do NOT attempt to repair
or remove the power switch or heating wire.
5. If you encounter any difficulties while installing your towel warmer,
call WarmlyYours for 24/7 installation support at (800) 875-5285.
6. If a return is necessary, please use original packaging if possible.