WarmlyYours TW-ST-06PS-PL-HD Towel Warmer Studio - Manuel

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
INSTALLATION
As shown in the picture, push the short
screw (6) through the hole in the sheet
metal of the bracket (1)
Tighten the short screw (6) with a screwdriver. Note that
the hole of the bracket (1) should face downward towards
the floor when the towel rail is mounted to the wall.
Attach the three remaining brackets (1) to the vertical tubes
by repeating steps 1 through 3.
Use a tape measure to measure the distance between
these four mounting holes. Use the tape measure to get
the distances of A-B, A-C, C-D, B-D, A-D, and B-C.
Use a drill with an appropriately sized drill bit to make the
holes for A, B, C, and D. If mounting to a stud, only drill
holes B & D.
Use the short screw (6) to attach the bracket
onto the metal pad located on the rear of the
vertical tube.
PAGE 1
TOOLS REQUIRED
Use a pencil to mark locations A, B, C, D on the wall
according the measurements. We suggest mounting the
Towel Warmer at least 24” (600mm) above the floor. We
suggest mounting the left rail of the towel warmer to a
stud, if possible.
A B
C D
600mm
1
2
3
4
5
7
+
STUDIO TOWEL WARMER INSTALLATION MANUAL
ITEM# TW-ST-06PS-PL-HD
6
(1) + (2) Round Wall hang bracket + set screw
(3) 3pc Bushings and 1pc short tube for wall bracket
(4) Long screw
(5) Plastic wall anchor
(6) Short screw
(7) Hex Key Wrench
1. & 2.
3.
4.
5.
6.
7.
ACCESSORIES