Swiss+Tech Key Ring Multi-Tool 7-in-1 - Manuel

Limited One Year Warranty
This product is covered by a Limited One Year Warranty
to the original purchaser in that this product is free
from defects in workmanship and materials. During the
warranty period, these products will either be repaired
or replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WAR-
RANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT
LIMITED TO, IMPLIED WARRANTY OF MERCHANT-
ABILITY OR FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH
® brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139
Key Ring Multi-Tool 7-in-1
www.swisstechtools.com 800-414-8799
ST74051
These products contain button batteries.
IF SWALLOWED, batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
•
DO NOT dispose of batteries in fire,
batteries may explode or leak.
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard
(carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
• REMOVE BATTERIES from equipment
which is not to be used for an extended
period of time.
Made in China. SWISS+TECH ® is a registered
trademark and First In Key Ring Products™ is a
trademark of Swiss+Tech Products. Specifications
are subject to change without notice.
©2010 Swiss+Tech Products, Solon, OH 44139
BATTERY WARNINGS:
Key Ring
Multi-Tool
7-in-1
5
4
2
3
6
11
7
Features a razor sharp knife blade.
Make sure the cutting edge is always
positioned away from the user.
CAUTION!
1. LED Flashlight
2. Phillips Screwdriver
3. Knife
4. Awl
5. Bottle Opener
6. Flat Screwdriver
7. Key Ring
BATTERY REPLACEMENT
1. Using a small Phillips screwdriver, turn
counterclockwise to remove the three
screws. Gently lift the Top Cover off to
expose the Battery Compartment.
2. Remove old batteries.
3. Replace with two new CR927 3V
lithium batteries or equivalent. Be sure to
position the positive (+) and negative (-)
sides as shown in the illustration.
4. Replace the top cover and the Phillips
screws. Be careful not to over tighten.
Top Cover
Under-Cover
Under-Cover
Batteries
Batteries
Metal Plate
Metal Plate
PVC Sleeves
PVC Sleeves
Top Cover