Aquascape AquaSurge PRO (45009 & 45010) - Manuel (Page 6)

6
☎ US 1-866-877-6637 | ☎ CAN 1-866-766-3426 | www.aquascapeinc.com
• Install the right sized
Multi-Hose based on the
diameter of the tubing you
are using.
• Lower the pump into the skimmer (refer to image) or
pondless ® filter (refer to image) and rotate the rotational
ball output to line up with the tubing. Attach tubing to the
fitting and then tighten a hose clamp (not included) to secure
tubing onto the fitting.
• If using pipe with a larger
diameter than the smaller
fittings of the Multi-Hose
Adapters, cut off the
smaller section to avoid
any flow restriction.
Or Application d’une écumoire
• Plug the pump into the Receiver.
• Plug the Receiver into an external GFI-rated electrical source.
in-line OPeratiOn
• The AquaSurge
® pro pump can also be operated “in-line”
by attaching a pipe connected directly from the pond (or
aquarium) to the male-threaded pump inlet. in this case the
water must be pre-filtered of debris in order to prevent any
damage to the pump or impeller. the pump must NeVer be
operated dry without water. this pump is water-cooled and
requires water flowing through the pump at all times
for the pump to operate correctly and stay cooled so
it doesn’t overheat.
Application pour cascades sans bassin (Pondless MD )
OPeratiOn and MaintenanCe
Remote Control and Receiver Operation
• Receiver Switch – the receiver includes a switch that allows
the pump to be operated in the two following modes:
O Position 1 - operated by remote Control
– Position 2 - bypass the remote, and operate at full
flow-rate
in the event of a power loss when operating in the remote
Control setting, the pump will revert to the last flow-rate setting.
45015 AquaSurge PRO Instruction Manual 11-11.indd 6 12/7/11 5:03 PM