Aquascape 210 GPH Statuary (99534) Manuel d'utilisation

Year, Statuary pump, De 1 an

Advertising
background image

Adapter

Motor

Impeller

Pump Covers

Pre-Filter

Supports

Congratulations on your purchase of

this submersible pump.

You will find this pump ideal for use in water gardens,

ponds and to power small ornamental fountains and

statuaries. These pumps are very energy efficient, using

50% less power than conventional pumps. They are

designed to be operated fully submerged. Made with

environmentally friendly materials, they are fish safe.

The pumps are fitted with a pre-filter system to prevent

clogging and wear on the impeller. The motors are epoxy

encapsulated, not oil filled and are CSA approved.

Features

PaCkage InCludes:

• 210 gph Statuary Pump
• Instructions for Use

Statuary Pump

210 gph Installation Instructions

• Fully submersible and energy efficient

• Powers ornamental fountains and statuary

• Prefilter system built in prevents clogging

• Fish safe, environmentally friendly materials

RePlaCeMenT PaRTs

To order replacement parts, contact your local Aquascape™ retailer.

Made in Italy for

Aquascape, Inc.

St. Charles, IL 60174 • Brampton,ON, L6T 5V7

www.aquascapeinc.com

Item #99534.052006

saFeTY COnsIdeRaTIOns

• This product must be installed on an electrical circuit protected by a Ground Fault Circuit

Interrupter (GFCI). Refer to your electric supply dealer for details.

• If you have any questions or doubts about this product, consult a qualified electrician.
• Do not lift the pump by the power cord — it is not designed for portable use.
• Always disconnect from electrical supply before attempting to service or perform

maintenance procedures.

Troubleshooting

Reduced Flow:
• Check pump and impeller for any blockages. It may

be necessary to take the impeller and prefilter out

and clean them.

• Check pipe and plumbing for any kinks or blockages.

Pump is not pumping:
• Make sure nothing is blocking the impeller. It may be

necessary to clean pump.

©2006 aquascape, Inc. • all Worldwide Rights Reserved

IDD 06044481-ADI B060201

1

YEAR

WARRANTY

1

GARANTIE

DE 1 AN

2

YEAR

WARRANTY

2

GARANTIE

DE 2 ANS

3

YEAR

WARRANTY

3

GARANTIE

DE 3 ANS

1

YEAR

WARRANTY

1

GARANTIE

DE 1 AN

2

YEAR

WARRANTY

2

GARANTIE

DE 2 ANS

3

YEAR

WARRANTY

3

GARANTIE

DE 3 ANS

This 210 gph Statuary Pump #99534 is warranted

against defects in materials or workmanship for a

period of 24 months starting at the date of purchase

by the customer. This is the

only warranty applicable

for this product. Our obligation under this warranty

is limited to the repair or replacement of the product

if it fails to operate. Neither Aquascape™, Inc. nor

the seller is liable for injury, loss or damage related

to the use of the product. However, this limitation is

not applicable in some states.

The warranty is void if any of the following is found:

1) Abuse of product by the customer.

2) Product connected to an electrical supply other

than specified.

3) Power cord cut to a length of less than three feet.

4) For pumps: (a) sealed motor housing opened;

(b) pump operated dry, with fluid supply shut

off and (c) pump used to circulate material other

than fresh water, light oils or other mild liquids at

approximately room temperature.

Installation

1) If a fountain is not required, connect hose

directly to the outlet adapter and secure with

hose clamp.

2) Place pump in pond. If fountain is in use, ensure

fountain head is above water level. The pump

should always be submerged in water and never

run dry.

3) Plug pump cord into grounded outlet. Ensure

cable is protected — keep away from children

and garden hazards.

Maintenance

1) Remove pump from electrical supply.
2) Wash pre-filter in fresh, running water. Never use

chemical detergents when cleaning. Handle filter

sponge material carefully.

3) Remove impeller, inspect and clean in running

water; replace if worn or damaged.

4) Reassemble pump; reconnect to electrical supply.

MaInTenanCe nOTes:
• Check cord periodically for sharp bends and correct.
• If pump is taken out of service, flush with fresh water and

allow to drain dry prior to storage.

Impeller Cover

Model

gph full

open

Cord

length

gph

@ 2’

gph

@ 4’

Max

Head

Tubing

size

Watts

size

Code

210 gph

210

6’

190

110

4ft.

1/2”

12

S

Pump Performance

Replacement Part

Item #

200 gph Impeller

20351

99534 210 GPH Statuary Instructi1 1

5/11/06 2:41:49 PM

Advertising