Aquascape Short Arm Water Fill Valve Manuel d'utilisation
Short arm, Water fill valve kit
Installation Instructions
Made in China for
Aquascape, Inc.
St. Charles, IL 60174 • Brampton,ON, L6T 5V7
www.aquascapeinc.com
Item #29933.042007
Care and MaIntenanCe
• The water fill valve requires no additional maintenance once it is set to the desired
water level.
• Regular pond maintenance, such as removing debris from the skimmer bag will
help the water fill valve operate accurately.
• Winter preparation -
the water fill valve will not operate during extended freezing
temperatures. Simply detach brass garden hose adaptor from water spigot. No
additional steps need to be taken to clear water from the 1/2” poly-pipe irrigation.
Installation
©2007 aquascape, Inc. • all Worldwide rights reserved
IDD 07035248-ADI 070187
Drill a 7/8 inch hole, one inch
below the ridge of skimmer.
Exact location for the water fill
valve will be different for each
skimmer. Just be sure that the
drill hole will be well above the
final water level.
Remove brass hex
nut, from threaded
end of float valve,
leaving only the
rubber washer on the
fill valve.
1
2
Insert threaded end of fill
valve through the 7/8 inch
hole drilled in the skimmer.
Note: rubber washer must be located
on the inside of the skimmer wall.
Tighten brass hex
nut, securing the
fill valve to the
skimmer box.
Thread the plastic adapter
(Part C or E) to the threaded
end of the fill valve. If using
Part C, be sure to use PVC
Primer and glue before
connecting pipe. If using
part E, slide tubing over
fitting and secure with
hose clamps provided.
3
4
5
*
When connecting to irrigation system, bury the pipe in the ground going back to the water source. If connecting to a sprinkler system, you may need to contact
a local irrigation specialist for help.
When connecting to a
garden hose, use the
brass adapter to connect
the AutoFill to the
graden hose.
6
adjustIng the Water FIll ValVe
• Initial positioning of fill valve arm can be made by loosening thumb screw & wing nut found
on the axel of the fill valve arm and adjusting the angle of the arm. Note: Axle point on arm
can be stripped if the thumb screw & wing nut are not loosened
prior to adjustment (see diagram A to right).
• Final adjustments of the fill valve should be made
while the pump
is operating and the water in the pond is at the desired level.
• Final adjustments can be made by
simply bending the fill arm
until the fill valve shuts the water off at the desired level. (see
diagram B to right).
PaCkage InCludes:
A) Autofill
B) Brass .5FPT x .75FPT garden hose adapter
C) Plastic .5FPT-.5S adapter
D) Plastic .5MPT-.5S adapter
E) Plastic .5FPT x .5 barb fitting
F) Plastic .5MPT x .5 barb fitting
G) Two #8 clamps
A
B
For more information about this or any of our other products,
please visit our website at www.aquascapeinc.com
Short Arm
1
/
2
” Water
Fill Valve Kit
(Formerly Pondsweep autoFill)
B
d
F
C
e
g
a
29933 Short Arm Water Fill Valve1 1
5/11/07 4:35:52 PM