Troubleshooting – Whirlpool WFW86HEBW Manuel d'utilisation

Page 18

Advertising
background image

18

Normal washer operation.

Door must be completely closed and latched for washer to run.

Washer will pause during certain phases of cycle.

Do not interrupt cycle.

The washer pauses for about 2 minutes during certain cycles.

Allow the cycle to continue. Some cycles feature periods of

tumbling and soak.

Washer may be stopped to reduce suds.

Cold Wash uses less water in the beginning of the cycle to

provide a high concentration of detergent for optimal cleaning

action. Following this concentrated tumbling, more water is

used to complete the wash.

Plug power cord into a grounded 3-prong outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Check electrical source or call an electrician to check if voltage

is low.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.

Washer not loaded as recommended.

Remove several items, rearrange load evenly in washer drum.

Close door and touch and hold START.

Do not add more than 1 or 2 additional items after cycle has

started to avoid tightly packing or unbalancing.

Do not add more water to the washer.

If you experience

Possible Causes

Solution

Washer won’t run or fill,

washer stops working

Check for proper water supply.

Both hoses must be attached and have water flowing to

inlet valve.

Both hot and cold water faucets must be turned on.

Check that inlet valve screens have not become clogged.

Check for any kinks in inlet hoses, which can restrict water flow.

Check proper electrical supply.

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.

Washer not performing as expected (cont.)

The washer door is not firmly shut.

The door must be closed during operation.

TROUBLESHOOTING

Advertising
Ce manuel est liée aux produits suivants: