Washer maintenance, Washer care (cont.), Removing the dispenser – Whirlpool WFW86HEBW Manuel d'utilisation

Page 14: Clean washer cycle reminder

Advertising
background image

14

WASHER CARE (cont.)

Cancellation of Clean Washer Cycle Operation:
If the Clean Washer cycle is canceled by the user after it has

been initiated, it may take up to 30 minutes for the washer

to purge any affresh

®

Cleaner, chlorine bleach, or other

chemistry from the wash system and to adequately rinse any

remaining chemistry. The washer door will remain locked until

the cancellation process has been completed. This ensures

no cleaning chemistry will be carried over to the next wash

cycle and reduces the potential for damage to subsequent

loads of laundry or to the washer itself.

Clean Washer Cycle Cancellation Procedure:
1.
Touch POWER on the washer once.
2. The washer will begin to drain and rinse away the

remaining cleaning chemistry.

3. The cycle will complete the cancellation process in

approximately 30 minutes or less.

4. The washer then can be used to either repeat the Clean

Washer cycle or to wash laundry using one of the regular

wash cycles selected by the user.

Cleaning the Dispensers
After a period of using your washer, you may find some

residue buildup in the washer’s dispensers. To remove

residue from the dispensers, remove the drawer and wipe

the surfaces with a damp cloth and towel dry either before

or after you run the Clean Washer cycle. Use an all-purpose

surface cleaner, if needed.
IMPORTANT: Dispenser is not dishwasher safe.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe up any spills.

Occasionally wipe the outside of your washer to help

keep it looking new. Use mild soap and water.
IMPORTANT: To avoid damaging the washer’s finish, do not

use abrasive products.

REMOVING THE DISPENSER

To remove:
1.
Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out to

remove the dispenser.

3. Lift off cover panel by

pulling straight up.

To replace:
1.
Slide cover panel back

onto posts on dispenser.

2. Align edges of dispenser

with guides in washer,

then slide dispenser

back into slot.

WASHER MAINTENANCE

CLEAN WASHER CYCLE REMINDER

The Clean Washer LED will flash at the

end of a wash cycle when the washer

has run 30 wash cycles. This is a

reminder to run the Clean Washer cycle.
If the Clean Washer cycle is not turned on, the LED will

stop flashing at the end of a wash cycle after running 3

more regular wash cycles. After 30 more wash cycles are

completed, the Clean Washer LED will again flash at the end

of a wash cycle as a reminder.

Advertising
Ce manuel est liée aux produits suivants: