Agri-Fab 45-0418 - Manuel (Page 8)

8
FIGUre 14
FIGUre 13
Attach the housing anchor straps to the 12. outside of the
mounting tubes using (4) 1/2" x 2-1/4" hex bolts, (8)
1/2" washers and (4) 1/2" nylock nuts.
Do not tighten
yet.
ANGLE
SLOPES
BACKWARD
1/2" WASHER
1/2" NYLOCK
NUT
1/2" X 2-1/4"
HEX BOLT
HOUSING
ANCHOR
STRAP
MOUNTING
TUBE
CAUTION : Use caution while working
on snow thrower when it is propped up on
concrete block.
Place a 15" concrete block underneath the snow 11.
thrower, beneath the engine. See figure 10.
Place the push channel over the ends of the mounting 15.
tubes. Line up the holes as shown in the figure below
and secure the push channel using (2) 1/2" x 3-1/2"
hex bolts, (4) 1/2" washers (one on each side) and (2)
1/2" nylock nuts.
Do not tighten yet.
1/2" NYLOCK
NUT
PUSH
CHANNEL
1/2" WASHER
1/2" x 3-1/2"
HEX BOLT
FIGUre 11
Attach the front holes of the housing anchor straps to 13.
the weld bolts on the housing using (2) 1/2" lock nuts.
Do not tighten yet.
1/2" LOCK NUT
Secure the mounting tubes to the side support straps 14.
using (2) 1/2" x 2-1/4" hex bolts, (4) 1/2" washers (inside
and outside) and (2) 1/2" nylock nuts.
Do not tighten yet.
NOTe: Concrete block not shown for clarity.
1/2" WASHER
1/2" NYLOCK NUT
1/2" X 2-1/4"
HEX BOLT
FIGUre 10
FIGUre 12