Agri-Fab 45-0418 - Manuel (Page 7)

7
FIGUre 9
4" Strut Mount
Polaris
Strut Mount
5-1/2"
Strut
Mount
6-5/8" Strut
Mount
6-5/8" Strut
Mount
Bombardier
Outlander Strut
Mount
5/16" x
1-1/2"
1/2" x 2-1/4"
3/8" x 2"
3/8" x 2"
3/8" x 2"
3/8" x 2"
ATV Lower
A Arm
1/2" x 4-1/2"
HEX BOLT STABILIZER
BRACKET
1/2" NYLOCK NUT
3" LONG
SPACER
SNOw ThrOwer ASSeMBLY
Remove any CV boot guard or stick guard from the 1.
front lower A arms of the ATV. Select the correct strut
mount assembly shown in figure 6 for your ATV. If your
ATV is not listed in figure 6, start with the 5-1/2" strut
mount assembly. If you use the 4", 5-1/2" or 6-5/8" strut
mount assemblies, attach with the strut mount on the
bottom of the A arm and the bolts on the outside of the
A arm.
Do not tighten bolts at this time.
Assemble the stabilizer brackets together using (2) 2.
1/2" x 4-1/2" hex bolts, (2) 3" long spacers and 1/2"
nylock nuts as shown in figure 7.
Do not tighten yet.
FIGUre 8
OUTER MOUNT STRUT
COLLAR
COLLAR
INNER
MOUNT
STRUT
1/2" x 3"
CLEVIS PIN
HAIRPIN
COTTER
HAIRPIN COTTER
1/2" x 3"
CLEVIS PIN
Slide a collar over the end of the outer mount strut. 3.
Slide the outer mount strut through the brackets 4.
assembled in step 2.
Slide a second collar over the end of the outer mount
5.
strut.
Apply a light coat of grease to the inner mount strut
6.
and then insert it into the outer mount strut.
Tighten
7. the bolts assembled in step 2.
Fasten the ends of the inner and outer mount struts 8.
to the strut mount assemblies that you attached to the
ATV's A-arms. Use two (2) 1/2" x 3" clevis pins and two
(2) hairpin cotters.
Tighten
9. the bolts and nuts assembled in step 1 that
fasten the strut mount assemblies to the A-arms.
Center the stabilizer brackets under the ATV. Slide the
10.
collars up against the stabilizer brackets and tighten
the set screws in the collars. The stabilizer brackets
must rotate freely after the collars are tightened.
NOTe: The ATV is not shown below for clarity.
FIGUre 6
FIGUre 7