Service and adjustments, Maintenance – Agri-Fab 45-0418 Manuel d'utilisation

Page 15

Advertising
background image

15

SerVICe AND ADJUSTMeNTS

SKID ShOe ADJUSTMeNT

The skid shoes are mounted on each side of the spiral

auger housing. They regulate the distance the scraper
plate is raised above the plowing surface. When
removing snow from a gravel driveway or and uneven
surface, it is advisable to keep the scraper plate as
high above the surface as possible to prevent possible
damage to the spiral auger. On blacktop or concrete
surface, keep the scraper plate as close to the surface
as possible.
Raise snow thrower off the ground and place a block

under each end of the scraper plate. Loosen the six hex
nuts securing the skid shoes to the housing. Adjust the
skid shoes up or down and retighten the nuts securely.
Adjust both skid shoes to the same height to keep the
housing and the scraper plate level. See figure 31.

SPIrAL AUGerS

The spiral augers are secured to the auger shaft with

two shear bolts and nylock nuts. If you hit a foreign
object or if ice jams the augers, the snow thrower is
designed so that the bolts will shear.
If the augers will not turn, check to see if the shear

bolts have sheared. See figure 30. Two replacement
shear bolts and nylock nuts have been provided with
the snow thrower. For future use order part number
710-0890A shear bolt and number 47810 nylock nut.

CAUTION

: Before servicing or adjusting

the snow thrower, shut off snow thrower and
ATV engines, remove the spark plug wire(s),
set the parking brake and remove the key
from the ignition.

CUSTOMer reSPONSIBILITIeS

Read and follow the maintenance schedule and the maintenance procedures listed in this section.

Service Dates

Check for loose fasteners

X

Check scraper and shoes for wear

X

X

Cleaning

X

Lubrication Section

X

Check engine oil level

X

Maintain engine per instructions below and in engine manual.

MAINTENANCE SCHEDULE

Fill in dates as you

complete regular service.

Bef

ore each use

After each use

Ev

ery season

Bef

ore stor

age

LUBrICATION

Oil all pivot points on the snow thrower.

Oil pivot points of two idler arms on the clutch/idler

assembly.
Apply penetrating oil to the control cables of the

discharge chute.
Fill grease zerks on front wheels and spindles with

grease.

MAINTeNANCe

CheCK SCrAPer AND ShOeS FOr weAr

The scraper plate and skid shoes on the bottom of the

snow thrower are subject to wear. To prevent damage
to the spiral auger housing, replace plate and shoes
before wear is excessive.

eNGINe MAINTeNANCe

Check oil level before each use. Maintain engine oil as

instructed in the separate engine manual.
Perform spark plug or other maintenance as instructed

in the separate engine manual.

FIGUre 30

FIGUre 31

SheAr BOLT AND
NYLOCK NUT

Advertising