Napoleon Fireplaces EPI3C - Manuel (Page 26)

W415-1087 / A / 06.06.13
26
EN
7.7 GLASS / GASKET REPLACEMENT
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.2
TRADITIONAL FRONT CONTEMPORARY FRONT
A. When the appliance is cool, remove the door and place it face down on a soft surface. Be careful not
to scratch the paint.
B. Remove the outer gasket, then remove the 9 screws (4 top and 5 bottom) on the Traditional front, or
the 6 screws on the Contemporary front, that secure the glass retainers. Retain all hardware.
C. Carefully remove the glass and the inner gasket below.
D. Apply a small bead of silicone in the gasket groove.
E. Place the 1/4” (6.4mm) rope gasket in the groove on top of the silicone.
F. Place the glass on the door and reinstall the glass retainers.
G. Apply a small bead of silicone in the groove for the outer gasket and insert the 1/2” (12.7mm) rope
gasket in the outer groove.
H. At the end of each burning season, inspect the door gasket for wear and check that it is secure.
Replace with 1/2” (12.7mm) diameter high density fi berglass rope if necessary.
NOTE: For replacement glass size, thickness and specifi cations see “REPLACEMENT PARTS” section.
IMPORTANT: ENSURE THE
RETAINER HAS THE DIMPLE
FACING UPWARDS, AS SHOWN.