Napoleon Fireplaces EPI3C - Manuel (Page 21)

W415-1087 / A / 06.06.13
21
EN
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from
this condition is not covered by the warranty policy. Use of the blower increases the output of heat.
Keep the blower opening free from ash build-up.
This appliance is equipped with a micro (pressure) switch, the micro switch shuts off the blower when the
door is open. This helps to reduce smoke from being blown into the room, and a thermally activated switch.
The blower will only operate when the door is closed and the thermally activated switch reaches temperature
(approximately 15-30 minutes depending on the intensity of the fi re.
A. Open the door and adjust the variable speed switch to desired speed. (It is necessary to depress the
micro switch when making this adjustment.
NOTE: For highest effi ciency, do not operate the blower when the air control is set to its lowest setting.
Furthermore, operate the blower on a slower speed when the air control is not more than 3/8” (9.5mm)
open from its lowest setting, and operate on any speed when air control is on any other setting.
When the appliance is cool, vacuum ash out from the blower area, for improved performance and an
increased longevity.
NOTE: This blower has thermal overload protection. For optimal performance operate blower at all
times, while the appliance is fi red, except when the air control is set to its lowest setting.
!
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK.
TURN OFF THE ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES,
TRIMS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL VOID THE WARRANTY AND
CERTIFICATION.
ENSURE THAT THE BLOWER’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
CORD BENEATH THE APPLIANCE.
MICRO SWITCH
VARIABLE SPEED
SWITCH
6.6 BLOWER OPERATION