Napoleon Fireplaces EPI3C - Manuel (Page 17)

W415-1087 / A / 06.06.13
17
EN
A. Line up the 3 holes on the right retaining bracket with the corresponding holes on the right side of the
appliance. Screw into place as shown using 1/4-20 hex head screws. Repeat this procedure on the left
side of the appliance.
B. Using 1/4-20 round-head screws, thread the screw approximately half of it’s length into the keyed
bracket (2 per side).
C. Place the casting pieces face down on a protected surface and assemble as shown. Fasten the
securing brackets.
D. Screw the corner brackets into place as shown on both sides of the casting.
E. Lift the casting and place the keyed holes onto the 1/4-20 round head screws and rest the casting into
place. Adjust screws as necessary to stabilize the casting.
NOTE: To ensure the joints are fl ush adjustment may be necessary. To adjust the cast components
loosen the screws and then align the casting to desired position.
5.4 SURROUND INSTALLATION, CONTEMPORARY CAST
1/4-20 ROUND
HEAD SCREWS
RETAINING
BRACKET
A
B
KEYED BRACKET
(LEFT & RIGHT)
CORNER
BRACKET
SECURING
BRACKET C
D