Napoleon Fireplaces Grandville 42 - BGD42 - Manuel (Page 35)

W415-0777 / E / 08.26.13
35
EN
32.1
Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
GLOWING EMBERS
Tear the glowing embers into pieces and place along the
front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed edges
of the fi bre hairs will glow. The ember material will only glow
when exposed to direct fl ame; however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, Carbon deposits and delayed ignition. Phazer
tm logs
glow when exposed to direct fl ame.
33.1
Sprinkle vermiculite around the charcoal embers.
NOTE: Vermiculite is not to be placed on the burner.
34.1
Place the lumps in front of the logs in a realistic manner taking care not to block any of the burner ports.
!
WARNING
CHARCOAL EMBERS, VERMICULITE AND CHARCOAL LUMPS ARE NOT TO BE PLACED ON THE
BURNER.
6.6 GLOWING EMBERS
6.7 CHARCOAL EMBERS
6.8 VERMICULITE
6.9 CHARCOAL LUMPS
6.10 LOGO PLACEMENT
97.1A
Remove the backing of the logo supplied and place on the glass viewing door,
as indicated. ½"
(12.7mm)
LOGO
½"
(12.7mm)
Position the remote receiver in the valve compartment close to the electrical junction box. Ensure the
receiver is on top of the placement label, if equipped.
35.25
PLACE REMOTE
RECEIVER ON TOP
OF THIS LABEL
FIREPLACE BASE
JUNCTION
BOX
6.11 REMOTE RECEIVER PLACEMENT