Napoleon Fireplaces Grandville 36 - BGD36 - Manuel (Page 46)

46
W415-0773 / F / 08.26.13
EN
ROCK SUPPORT
BRACKET
LOG SUPPORT BRACKET
!
WARNING
(RAK-ROCK ADAPTOR KIT IS NECESSARY WITH THIS KIT).
REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE.
A. Remove all logs and media.
B. Remove the 2 screws and log support brackets
already installed in the fi rebox and secure the
rock support bracket along the back of the
fi rebox.
NOTE: When the porcelain panels are installed,
the rock support bracket is secured over the rear
porcelain panel. Tabs on rear porcelain panel must
be bent up to sit fl ush on the rock support bracket.
C. Move the two rock clusters into position,
lining up the studs located on the burner with
the holes in the bottom of the rocks. Ensure
the clusters are sitting fl at on the burner.
NOTE: For best results its recommended
you remove the grate and using Wolf
Steel approved paint, paint the surfaces
underneath where the grate was removed.
High temperature silicone can be used to
help hold the cutout rocks in place.
D. Place the large cut out rocks along the edge of
the rock support bracket as shown. E. Place the remaining refractory rocks around the
burner as desired, making sure not to cover
any burner ports.
(There are no set locations).
7.8 OPTIONAL ROCK KIT