Samsung RF4289HBRS-XAC - Manuel (Page 17)

setting up _17
01
SETTING
UP
Connecting the water supply line to the
refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing Use Plastic Tubing
• 6 mm copper tubing
• 6 mm compression
nut (1 pc)
• Ferrule (2 pc)
• 6 mm plastic tubing
→ Molded end (Bulb)
• 6 mm compression
nut (1 pc)
1. Connect the household water line to the
assembled compression fitting fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
- If you are using plastic tubing ( B ) , insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
Do not use without the molded end (Bulb)
of the plastic tubing (
B ).
2. Tighten the compression nut ( B ) onto the
compression fitting.
Do not over-tighten the compression nut (
B ) .
CAUTION
3. Turn water on and check for any leakage.
If you find water drops or leakage in the
connection areas, turn off the main water
supply. Check the connections and, if
necessary, tighten.
4. Flush 4 L of water through the filter before
drinking or using the water from the refrigerator.
(Flush approximately 6 minutes.)
To flush, press a large glass or cup against the
water dispenser lever.
Fill the glass, empty it into the kitchen sink after
it is filled, and then repeat.
5. After you turn on the refrigerator, let the ice
maker make ice for 1 to 2 days. Over that
period of time, throw out the first 1 or 2 buckets
of ice the freezer makes to ensure all impurities
have been removed from the water line.
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6 mm
of the plastic tubing to make sure you get
a snug, leak-free connection.
COMPLETING THE SET UP
Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1. Make sure your refrigerator is in an appropriate
location with reasonable clearance between it
and the wall.
Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour.
The freezer will get slightly chilled and the motor
will run smoothly. Reset the refrigerator and
freezer to the temperatures you want.
4. After you plug the refrigerator in, it will take a
few hours to reach the appropriate temperature.
You can store food and drinks in the refrigerator
after the temperature is sufficiently cool.
If condensation or water drops appears on
both sides of fridge door’s central part, turn
the Energy Saver mode off after removing
the condensation. (See the explanation on
Energy Saver button in the USING THE
CONTROL PANEL.)
Compression
Nut (6 mm)
(Assembled)
Ferrule
(Not supplied)
Plastic Tubing
(Assembled)
Compression Fitting
(Assembled)
Molded end (Bulb)
Compression nut ( B )
(6 mm) (Not supplied)
Copper tubing or Plastic tubing ( B )
(Not supplied)
Household water supply line
Refrigerator
(Not supplied)
DA68-02520B-04.indb 17 2013. 12. 10. �� 6:25