Samsung RF4289HBRS-XAC - Manuel (Page 16)

16_ setting up
ADJUSTING THE FREEZER
DRAWER LEVEL
1. Locate the height-adjuster ( 1 ) in the freezer
drawer. Unscrew the 8 Phillips screws ( 2 )
slightly to loosen the door.
2. Loosen the controller screw
( 3 ) with a Phillips screwdriver
(+).
3. Find the best level to align the door slope.
• After adjustment, tighten the controller screw
( 3 ) and then the philips screws.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a
water pressure of 20~125 psi (138~862 kPa) is
required. Under normal conditions, a 0.17 L cup
can be filled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and 6 mm compression nut.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
3. Connect the water line installation kit to the shut
off valve.
Freezer Drawer
Adjustment part
1
2
Example) The slope is about 2 mm as shown below.
- Rotate the height adjuster to -2.0 to reduce the door slope.
Slope
Reference plane
3
Pipe clamp
Cold water line
Shut off valve
Shut off valve
Pipe clamp
Cold water line
Water line installation kit
DA68-02520B-04.indb 16 2013. 12. 10. �� 6:25