Samsung RF4289HBRS-XAC - Manuel (Page 12)

12_ setting up
• Allow clearance to the
right, left, back and top
when installing.
This will help reduce
power consumption and
keep your energy bills
lower.
• Do not install the refrigerator where the
temperature will go below 10 ºC.
• Do not locate the refrigerator where it may
become wet.
When moving your refrigerator
To prevent floor damage, be sure the front
adjusting legs are in the up position (above
the floor).
Refer to ‘Adjusting the doors’ in the
manual (on page 14).
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the same
height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
CAUTION
ACCESSORIES AND REQUIRED
TOOLS
The following accessories are included with your
refrigerator:
Hex wrench Fastener
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
screwdriver (+)
Flat-blade
screwdriver (-)
Socket wrench
(10 mm)
Pliers Allen wrench (5 mm)
REMOVING THE REFRIGERATOR
DOORS
For some installations you need to remove the
fridge and flex doors and the freezer drawer so
you can move the refrigerator to its final location.
Do not remove the doors/drawer if you don’t need
to. If you do not need to remove the refrigerator
doors, go to Adjusting the Level on page 9. If you
need to remove the doors. continue below. Before
removing the door/drawer, make sure you read the
following items:
Disconnect power to the refrigerator before
removing the doors or drawer.
• Be careful not to drop, damage, or
scratch the doors/drawer while removing
them.
• Be careful not to injure yourself while removing
the doors/drawer.
• Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
WARNING
E E C C
A A
B B
D D
Flat-blade screw
driver(-)
Control Lever
DA68-02520B-04.indb 12 2013. 12. 10. �� 6:24