Kolpin 26400 - Utility Gear Rail System - Manuel (Page 3)

Rev. 03
STEP BY STEP INSTRUCTIONS:
1. Using the 4 – ¼” x 2.25” or the 5.50” Truss Head Bolts and ¼” Nylock Nuts mount the Left Hand
Extrusion End Cap on the dump bed side of the driver side roll bar. (Left side if looking from the
back of the machine). The Left Hand Plastic Clamp goes on the seat side of the roll bar. (See
Figure 1. Note: Picture is showing right side of machine for reference only). Tighten the hardware
so it is snug but do not fully tighten as the system may need to be raised or lowered in the vertical
plane. Note: If machine has a rear screen attached to the roll bar, the screen will need to be
loosened first to allow the Utility Gear Rail System to fit properly. If using Longer Bolts, you will
need to cut down the bolt to eliminate interference with the C-Clamp being able to slide on the
extrusion.
Figure 1
2. Next, from the right side of the machine, take the Aluminum Extrusion and slide onto the Left Hand
Extrusion End Cap. (See Figure 2)
Figure 2