JVC KD-R611 - Manuel (Page 12)

12 ENGLISH
For Bluetooth operations, it is required to
connect the Bluetooth adapter, KS-BTA200 (not
supplied) to the expansion port on the rear of
this unit.
• Refer to pages i and ii at the end of the
manual to check the countries where you
may use the Bluetooth ® function.
• For details, refer also to the instructions
supplied with the Bluetooth adapter and the
Bluetooth device.
To use a Bluetooth device through the unit
(“BT-PHONE” and “BT-AUDIO”) for the first time,
you need to establish a Bluetooth wireless
connection between the unit and the device.
• This unit may not be able to play the files
depending on the type of USB device.
• Operation and power supply may not work as
intended for some USB devices.
• You cannot connect a computer to the USB
input terminal of the unit.
• Make sure all important data has been backed
up to avoid losing the data.
• Do not leave a USB device in the car, expose
to direct sunlight, or high temperature to
avoid deformation or cause damages to the
device.
• Some USB devices may not work immediately
after attaching USB device or turn on the
power.
• For more details about USB operations,
32.
Stop playing and detaching the
USB device
Straightly pull it out from the unit.
“NO USB” appears. Press / SOURCE to listen to
another playback source.
You can operate the USB device in the same
way you operate the files on a disc.
(
10, 11)
Cautions:
• Avoid using the USB device if it might hinder
your safety driving.
• Do not pull out and attach the USB device
repeatedly while “READING” is shown on the
display.
• Do not start the car engine if a USB device is
connected.
Using Bluetooth ® devices
• Once the connection is established, it is
registered on the unit even if you reset your
unit. Up to five devices can be registered in
total.
• Only one device can be connected at a time
for each source (“BT-PHONE” and “BT-AUDIO”).
Registration (Pairing) methods
Use either of the following items (“OPEN” or
“SEARCH” ) in the Bluetooth menu to register
and make the unit ready to establish a new
Bluetooth connection with a device.
“OPEN”
: Connection is established by
operating the Bluetooth device.
“SEARCH” : Connection is established by
operating the unit.
EN12-21_KD-R611_003A_1.indd 12 EN12-21_KD-R611_003A_1.indd 12 10/27/09 11:45:53 AM 10/27/09 11:45:53 AM