Whirlpool 1188177 - Manuel (Page 9)

9
4. Plug into a grounded 3 prong outlet.
5. Press RESET on power supply cord.
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
■ Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 66°F (19°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTES:
■ In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
■ If the electronic control will not respond to touch pad or
remote control commands, it is necessary to unplug the unit
from the electrical outlet for 5 seconds before plugging
back in.
Starting Your Air Conditioner
Models without heat
Models with heat
1. Remove clear protective film from control panel.
2. Press POWER to turn on air conditioner.
NOTE: When the air conditioner is turned on, it will display
the previous settings for the mode, fan speed and
temperature.
3. Choose mode. See “Mode.”
4. Choose fan speed. See “Fan Speed.”
5. Choose temperature. See “Temperature.”
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.