Warning, Install air conditioner in new wall sleeve, Ac plastic grille install 2.eps – Whirlpool 1188177 Manuel d'utilisation

Page 7

Advertising
background image

7

3. If needed, drill

¹⁄₈" holes into the wall sleeve. Then fasten the

grille to the wall sleeve with the screws with washers.

4. If existing wall sleeve has insulation that does not need to be

replaced, skip to Step 7. Otherwise, replace the insulation.

5. Remove the backing from the horizontal insulation strip and

attach it to the inside of the wall sleeve.

6. Remove the backing from the vertical insulation strip and

attach it to the inside front of the wall sleeve as shown below.

7. If the depth of your existing sleeve is less than or equal to 18"

(45.7 cm), go to Step 10. Otherwise, cut the baffle and
support blocks according to the lengths in the following table.

8. Slide the baffles into the slots of the support blocks.

9. Slide the baffle and support block assemblies inside the wall

sleeve as shown.

10. Install the air conditioner into the wall sleeve.

11. The universal trim frame must be used with this wall sleeve

assembly. To assemble the universal trim frame, see
“Complete Installation.”

Install Air Conditioner in New Wall Sleeve

NOTE: Wall sleeve must be purchased separately.

Install the new grille that came with your air conditioner or
new wall sleeve.

NOTE: If this grille is not installed in the wall sleeve, your air
conditioner will not operate correctly and the warranty will be
void.

Handle air conditioner gently.

Be sure your air conditioner does not fall out of the opening
during installation or removal.

The place where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded outlet.

Be sure the wall where the air conditioner will be installed will
support the weight of the air conditioner.

Do not install the air conditioner where the plastic cabinet
front will be exposed to a heat source that raises the surface
temperature above 120ºF (49ºC).

Do not block the louvers in the front panel.

A. Vertical insulation strip
B. Horizontal insulation strip

A. Length (see chart below)
B. Support block

C. Baffle

Depth (D) of existing wall sleeve

Length (A)

18" (45.7 cm) < D < 18

⁵⁄₈" (47.3 cm)

³⁄₄" (1.9 cm)

18

⁵⁄₈" (47.3 cm) < D < 19³⁄₄" (50.2 cm)

1

³⁄₄" (4.5 cm)

19

³⁄₄" (50.2 cm) < D < 22 (55.9 cm)

4 (10.2 cm)

AC Plastic Grille Install 2.eps

OR

A

B

A

B

C

A

A. Wall
B. Front of wall sleeve

C. Baffle
D. Support block

A

B

C

D

7

³

/

₃₂

"

(18 cm)

Excessive Weight Hazard

Use two or more people to move and install
air conditioner.

WARNING

Failure to do so can result in back or other injury.

Advertising
Ce manuel est liée aux produits suivants: