Whirlpool GZ5736XR Series - Manuel (Page 7)

7
2. Disconnect the light assembly wiring connector.
Make sure not to disconnect any wires.
3. Remove the light panel and set aside.
4. Remove the air chute held in place with one screw.
5. Remove baffle from air chute.
6. Rotate baffle and reinsert it back into the air chute so that the
baffle tabs fit all the way into the slots in the air baffle.This will
close off the air flow through the non-vented slots on top of
the hood.
7. Replace air chute.
8. Connect light assembly wiring connector and replace light
panel.
NOTE: Make sure not to trap wires between the support fin
and light panel.
A
A. Light panel
A
A. Air chute
top of hood. Set vent plate and mounting screws aside.
2. Remove tape holding standard filters in place. Remove both
filters. Insert flat blade screwdriver into slots in filters. Push
each filter toward back of hood, lift out and set aside.
3. Remove damper/vent connector from inside the hood. Set
connector, mounting screws and parts bag aside.
4. Remove wiring cover from inside the hood. Set cover and
mounting screw aside.
5. Depending on your installation, remove either top or back
wiring knockout and install a
¹⁄₂" UL- or CSA-listed strain
relief.
For non-vented installations
Go to “Make Electrical Connection” section.
For vented installations
1. Remove the five screws holding the light panel in place and
set them aside.
A
A. Damper/vent connector
A
A. Wiring cover
A
A. Strain relief
A
A. Baffle
A
B
A. Tab slots
B. Tabs
A
B
A. Filter slots
B. Flat blade screwdriver