Whirlpool 3967363 - Manuel (Page 6)

6
P
ORTABLE ONE
-
FAUCET CONNECTION
( CONT
.
)
To disconnect washer:
• Unplug the electrical power cord and put it back in
its storage area.
• Turn the water faucet off.
• Press the red water flow button to release the
water pressure.
• Move the locking collar down and pull the hose
connector down to disengage from the faucet
adapter.
• Drain water from the hoses through the hose
connector.
• Hang the hoses on the storage rack.
P
ORTABLE TWO
-
FAUCET CONNECTIONS
IMPORTANT: Whirlpool Service Kit #3430190 must
be purchased when using a portable model on a
two-faucet connection.
NOTE: Make sure the lid is closed before
moving the washer.
If you have two separate water connections, your
washer can be connected to both the hot and cold
water faucets. For more information about a service
kit, contact your authorized Whirlpool dealer.
To connect the washer:
• Insert one new, flat washer into each end of the
water inlet hoses. Check that washers are firmly
seated in the couplings.
• Connect the hot and cold water inlet hoses to the
hot and cold faucets.
• Secure the drain hose to the sink or standpipe.
• Slowly turn the water faucets on all the way.
• Plug the power cord into a 3 prong grounded
outlet.
To disconnect the washer:
• Unplug power cord and return it to the storage
area.
• Turn water faucets off.
• Disconnect the drain and water supply hoses.
Hang them on the storage rack.
Locking collar
Water flow button Hose connector
C
H
WASHER INSTALLATION
WASHER COUPLING Coupling Washer