Tektronix Phaser Laser Printers 740L - Manuel (Page 28)

Getting Set Up
20 Phaser 740 and 740L Laser Printers
Turn on the printer
C A U T I O N
To protect your printer from a power surge, make sure that the printer’s power
switch is in the
off position before plugging in the cord.
1. Plug the power cord into the printer and into a grounded outlet.
2. Turn on the power to any peripherals you have connected.
3. Wait about 10 seconds, then turn on the printer.
■ The printer goes through a series of self-tests, taking about 3 minutes.
■ The Startup Page prints.
■ When the power-up sequence is complete, the green indicator is on
steady (not blinking), the amber indicator is off, and the front panel
message reads
Ready .
N O T E
You can set the printer so that it does not print the Startup Page every time it is
turned on. Refer to “Enabling and disabling the Startup Page” on the printer’s
CD-ROM or web site.
3101-20
1
3
A4 A4 PA PER ER