Add-ons/peripherals, Installing/removing the unit, Using a cd-rom drive – Panasonic CF-35 Manuel d'utilisation

Page 22

Advertising
background image

22

Add-ons/Peripherals

Devices capable of being used by your computer are listed in the table below.

You may use an optional CD-ROM pack (CF-VCD351) by removing your floppy disk drive
from the multimedia pocket. Should you decide to install the CD-ROM pack, it will function
as an internal CD-ROM drive. For more information, please read the manual that accompa-
nies the CD-ROM pack.

1

CAUTION

Do not shut down using the suspend or hibernation mode.

Do not install or remove peripherals while your computer is in the suspend or
hibernation mode; abnormal operation may result.

Installing/Removing the Unit

CAUTION

Removing the unit

2

Using a CD-ROM Drive

Please handle the unit as shown (holding both sides).
Otherwise, the unit may be damaged.
Do not allow dust to enter the multimedia pocket.
Use of the dummy FDD is highly recommended
when the floppy disk drive is not installed. When
inserting the dummy FDD, first make sure the guide
and groove match and then push the guide part of
the dummy FDD in.

Multimedia Pocket

below

PC Card Slots

page 23

Serial Port

page 39

RAM Module Slot

page 24

Expansion Bus Connector

page 25

Ext. Display Port

page 25

Parallel Port

page 25

Ext. Keyboard/Mouse Port

page 39

Headphone Jack

page 39

Microphone Jack

page 39

Device(s)

CD-ROM drive (CF-VCD351)
PC Cards (Modem, LAN, SCSI, etc.)
Serial Devices (Mouse, Modem, etc.)
Extra Memory
Port Replicator (CF-VEB351)
External Display
Printer
Keyboard, External Mouse

[Type PS/2]

, etc.

Speaker/Headphone
Microphone

Reference

Where to connect

Turn your computer over, slide the MP release lever using thumb and remove the
unit.

MP Release Lever

Power off your computer

(

page 10)

Groove

Guide

Installing the unit

After the lever returns to its original position, continue pushing in the unit from
both edges until it is firmly set.

Turn your computer on

3

CAUTION

You may use the floppy disk drive as an external unit that is connected through the
parallel port, by using an optional FDD cable (CF-VCF351). Some precautions are
necessary, as described below, since problems may arise.
• Do not move the drive while accessing data on the floppy disk.
• Firmly hold both sides of the drive when removing a disk. Excessive force on top

should be avoided.

The lever will return to this position
(right-side).

NOTE

Even after installing the CD-ROM Pack, [Removable Disk (A:)] is displayed in [My Com-
puter], but access is not possible. Select [Cancel].

Advertising