Panasonic CF-35 - Manuel (Page 10)

10
Cursor
Use the touch pad to move the cursor on the display and perform normal computer operations. It
is not necessary to apply too much pressure on the work surface.
Work Surface
Moving the cursor
CAUTION
Leaving your finger on the touch pad for more than 15 seconds will put your computer in
the Calibration mode. In this mode, there are instances where even if you slide your
finger on the work surface, the cursor will not move. In such cases, you have to lift your
finger from the work surface and apply your finger to the work surface again.
When using drawing applications like Paint, please try to draw in the center of the
work surface. There are cases where lines drawn later appear to have been drawn
incorrectly.
Using the Touch Pad
To shut down, save all data and select [Shut Down] from the
[Start] menu
1
If you want to immediately start up and continue an application after shutting down your com-
puter, you can do so by using the suspend or hibernation function.
Starting Up Your Computer Quickly
Restarting your computer (without shutting down)
Select [Restart] (or [Restart the computer?]), then press (or ).
NOTE
To quickly resume computer operation after shutting down,
the suspend and hibernation functions are available. ( below)
NOTE
Shutting Down (power off your computer)
From the keyboard,
you may choose to press down on then select [Shut Down].
2
Confirm shutdown
Select [Shut down] (or [Shut down the computer?]), then press (or ).
Your computer will power off automatically.
(In the OFF state, if you are not recharging your battery pack or if the pack is fully charged, your computer and
the AC adapter consume approximately 1.1W.)
Differences between suspend function and hibernation function
Function Where data is saved to Speed Requires power supply
Suspend function Memory Fast Yes (if power is cut, all data is lost)
Hibernation function Hard disk Somewhat slow Power not required to maintain data
Double-clicking Dragging Clicking
NOTE
While holding
down the button,
moving your fin-
ger on the work
surface
or or or
To change the touch pad settings, select [Mouse] in [Start] - [Settings] - [Control
Panel]. Even if [Left-handed] is selected in the mouse settings, tapping the touch
pad will have the same effect as clicking the left button of the touch pad.
One tap
One tap Two quick
taps Two quick
taps
Starting Up/Shutting Down
Two quick taps, but on
the second tap leav-
ing your finger down
(applying pressure)
and moving it on the
work surface. One tap
when your finger will
“drop” the object.
(The display varies depending on the
models.)